RHUB TM-510 Dokumentacja Pobierz pdf (Strona 154)

TM 92350-311 -34-1

7-6 DRIVER’S BULKHEAD-TO-MASTER RELAY WIRING HARNESS (M109A4/M109A5)

(ENGINE MODEL 7083-7396) – CONTINUED

a. Removal

Remove two screws

(28), two

Iockwashers (29), two nuts (30), and two connectors (26) from batteries (31).

Discard lockwashers.

2 Remove screw (32), washer (33), Iockwasher (34), nut (35), and strap (36). Discard Iockwasher.

3 Remove screw (37), Iockwasher (38), washer (39), and two ground wires (18 and 22) from voltage regulator

mount (40). Discard Iockwasher.

4 Disconnect connector (23) at wire 503.

5 Disconnect two wiring harnesses (41) from driver’s compartment side of bulkhead (42).

Remove eight nuts (43), eight Iockwashers (44), eight washers (45), and eight screws (46). Remove two

connectors (24 and 25) from bulkhead (42). Discard Iockwashers.

7 Disconnect four electrical connectors (19, 20, 21, and 27) and remove wiring harness.

b. Disassembly

1 Remove electrical tape only for sections being disassembled.

2 Separate/isolate wiring harness branches.

3 Disassemble wiring harness branches (TM 9-2350-311-20-1).

c. Assembly

1 Assemble wiring harness branches (TM 9-2350-311-20-1).

2 Apply electrical tape only for sections being assembled.

d. Installation

1 Install wiring harness and connect four electrical connectors (19, 20,21, and 27).

2 Install two connectors (24 and 25), eight screws (46), eight washers (45), eight new Iockwashers (44), and

eight nuts (43) to bulkhead (42).

3 Connect two wiring harnesses (41) to driver’s compartment side of bulkhead (42).

4 Connect connector (23) at wire 503.

5 Install two ground wires (18 and 22), washer (39), new Iockwasher (38), and screw (37) to voltage regulator

mount (40).

6 Install strap (36), nut (35), new Iockwasher (34), washer (33), and screw (32).

7-18

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 352 353

Brak uwag

RHUB TM-510 Dokumentacja Strona 154