RHUB TM-510 Dokumentacja Pobierz pdf (Strona 290)

100

101

TM 9-2350-311-34-1

10-2 COOLANT HEATER — CONTINUED

a. Disassembly — Continued

NOTE

Perform step 45 only if nameplate requires replacement.

45 Remove four blind rivets (88) and nameplate (89). Discard blind rivets.

46 Install two grommets (90).

b. Assembly

1 Install two grommets (90).

2 Install nameplate (89) and four new blind rivets (88) (if removed).

3 Spread housing (16) open and install heat exchanger (69).

4 Install three screws (87).

5 Install two spacers (86), restriction thermostat (18), two flat washers (85), and two new assembled nuts (84).

6 Install resistor motor (81), screw (83), and nut (82).

7 Install bracket (80) with resistor motor (81) and nut (79) to bracket (14).

8 Install marker strip (78), terminal strip (8), and four screws (77).

9 Install diode holder (74) and two screws (75 and 76).

NOTE

Check direction of arrow on diode to ensure proper positioning.

10 Install diode (73) to diode holder (74).

11 Install bracket (14) and four screws (72).

10-30

1 2 ... 285 286 287 288 289 290 291 292 293 294 295 ... 352 353

Komentarze do niniejszej Instrukcji

Brak uwag

RHUB TM-510 Dokumentacja Strona 290

Komentarze do niniejszej Instrukcji